Scope of work (Low Current System)
Supply and installation of an Exterity IPTV system serving 156 rooms, integrated with a complete Televes satellite dish farm. This SOW is structured to be used for tendering, project execution, or contractual purposes.
1. Satellite Dish Antennas (Televes)
Supply and install Televes aluminum satellite dishes (offset design) for corrosion resistance, lightweight construction, and long service life.
Supply 130cm & 100cm dishes to receive Astra, Hotbird, Eutelsat, Arabsat and Nilesat signals for a typical 156-room configuration.
Supply and install Televes Quattro LNBs for each dish, with ultra-low noise figure ≤0.3 dB and high gain ≥60 dB for optimal signal quality across long cable runs.
Install a centralized Televes multiswitch system (cascaded MS524C, 5-input/24-output) to combine signals from all dishes and feed the Exterity IPTV gateways with correct polarization/band routing, allowing for future expansion.
Supply and install Televes multiband headend amplifiers (Minikom Launch LTE700) to boost signal without distortion or intermodulation.
Provide RF redistribution over coaxial networks using Televes T.0X or T12 series headend amplifiers to mix multiple satellite and terrestrial channels into a single coaxial output.
2. Coaxial Cabling & Passive Components (Dish to IP Gateway Location)
Supply and install high-quality coaxial cable (RG-6 or RG-11, double-shielded, low-loss) from each LNB to the multiswitch inputs, and from multiswitch outputs to the Exterity satellite gateway inputs.
Provide all necessary F-type connectors, ground blocks, lightning arrestors, splitters, and attenuators for a clean, interference-free signal path.
Document dish alignment coordinates (azimuth, elevation, polarization), multiswitch port mapping, and signal level measurements at each point.
Perform end-to-end RF signal verification (carrier-to-noise ratio, bit-error rate) before connecting to the Exterity system.
3. Exterity IPTV Headend & Signal Processing
Supply and install Exterity AvediaStream TV gateways for DVB-S/S2 satellite input (g4418/g4415 high-density gateways for 20–80 channels, g4315 for smaller channel counts, g4417-pi for content-protected channels).
Size tuner count for 156 rooms using multicast streaming – estimate 30–50 tuners for a standard hotel package of 50 international and local channels.
Install gateways in a 19-inch equipment rack in the central headend (data center or telecom room).
Configure each gateway to descramble (via Conditional Access Modules where provided) and demodulate DVB-S/S2 signals, output MPEG-2/H.264 transport streams over UDP/RTP multicast to the LAN, and be managed via Exterity’s AvediaServer Director.
4. Exterity HDMI Encoders & AvediaServer Platform
Supply and install Exterity AvediaStream HDMI encoders (e3830) to encode local video sources (welcome channel, information channel, digital signage, promotional content), accepting HDMI input up to 1080p and outputting an H.264 IP multicast stream.
Provide required source devices (media player for looping welcome video).
Supply and install the Exterity AvediaServer hardware platform and licensed software (AvediaServer c1520 or c1565, sized for 156 rooms) as the core of the IPTV system.
AvediaServer to provide middleware for the user interface, EPG and guest portal; device management for gateways, encoders and receivers; a VOD server and library storage; digital signage content management; and PMS integration for guest name display, check-out and billing (e.g. Opera, Fidelio).
License AvediaServer for 156 concurrent active endpoints and the number of live TV channels delivered.
Provide a dedicated IPTV VLAN with IGMP snooping enabled, QoS (DiffServ/DSCP) prioritization for video streams, Cat 6A copper cabling from all headend devices to the core switch, and LACP link aggregation on AvediaServer ports for bandwidth and redundancy.
5. In-Room System – Smart TV (without STB)
Supply 156 hospitality-grade LG Smart TVs pre-loaded with the Exterity ArtioGuest client (or compatible middleware application), eliminating the need for separate STBs.
Connect Smart TVs to the network via wired Ethernet, with Cat 6A cabling terminated from each room outlet to the floor distribution switch.
Install one double-gang faceplate per room with an RJ-45 data port for the Smart TV (and optionally a second port for guest Wi-Fi), labeled with unique room identifiers.
Deliver live TV with channel list, EPG, favourite channel selection and parental control; a VOD library; language selection (Arabic, English, French) and accessibility features (subtitles, audio description).
Provide guest services including welcome message with guest name (via PMS integration), wake-up call scheduling, room service ordering, housekeeping requests, concierge information, and check-out/bill viewing.
6. Central Management & Monitoring
Provide AvediaServer Director software for centralized configuration and firmware updates across all Exterity devices, real-time monitoring of device health, bandwidth usage and stream status, and logging/alerting via SNMP traps to the facility’s network management system.
Provide a content management interface for the hotel IT team to update the VOD library, modify the EPG, edit the guest portal’s welcome messages/branding/menu items, and manage user access and permissions.
Integrate with the PMS (as required) via standard API or Exterity’s PMS gateway module for guest name, check-out and billing data exchange.
7. System Integration & Dependencies
Rely on the facility LAN (existing or newly installed managed Ethernet network) to carry multicast video traffic with IGMP snooping, PIM (if required) and QoS.
Extend IPTV access over the guest Wi-Fi network where available, allowing guests to watch TV on tablets or smartphones.
Integrate with the Property Management System (PMS) for interactive guest services.
Connect all headend equipment (gateways, AvediaServer, core switches, multiswitch power supplies) to an online UPS with sufficient runtime to maintain service during short power interruptions.